Publicidad
Idiomas disponibles
Idiomas disponibles
5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.
5.2 Use
WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The device must be completely removed from its packaging. All guards must be fully
withdrawn.
Place the device on a solid, flat surface.
Do not install the cup warmer in a humid or wet environment.
Do not install the cup warmer on a flammable surface.
Do not install this device near open fires or other heating devices.
The electrical cable must be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a power strip will trip the device.
Clean the cup warmer using a soft, damp cloth.
EN
Publicidad
