Vestergaard LIFESTRAW MAX Manual Del Usuario página 7

SETUP | CARBON FILTER INSTALLATION
INSERT CARBON BLOCK WITH BLACK
4
O-RING ON TOP
Place the carbon filter, with the black silicone
ring facing outward, into the gray carbon filter
housing. Screw the gray carbon cartridge lid on
tightly.
5
REASSEMBLE CARBON FILTER HOUSING
Make sure that the bottom of the gray carbon filter housing is
in place by pressing firmly into the fitting. Double check that
the side cartridge connectors are firmly in place with the black
seal flush against the inside.
NOTE: If you removed the carbon filter housing from the Max to insert the carbon block,
reinsert by fitting the bottom of the cartridge into the plug fitting located in the bottom of
the Max. Ensure the two side connectors are lined up to their matching pieces and press
firmly to make sure they are in place.
RECONNECT WHITE FILTER HOUSING
6
BRIDGE
Reconnect the top filter housing bridge
by lining up the tabs with their associated
slots and pressing down until it clicks into
place, indicating it is fully locked.
7
CLOSE TOP LID
Place the top lid back onto the top of box, sliding the lid locks
toward the corners to secure.
NOTE: When replacing your carbon filter, follow these instructions. Remember to perform
the backwash procedure after any filter replacement.
7