Required Tools; Mounting Location - Velleman SPBS4 Manual Del Usuario

1. blind zone
c) Precautions
Keep the sensors clean and remove dirt from the surface if necessary
Make sure the sensors are kept stable in the right position.
Replace defective sensors
Final test is necessary before use
6. Installation

6.1. Required tools:

voltage test screwdriver or multimeter
insulating tape
pencil
cable clip
electric drill
hole cutter
tape rule
triangular file
flat screwdriver
Phillips screwdriver
a pair of pliers
Note: The drill bit, cable clips and double-sided adhesive tape are included in the gift box.

6.2. Mounting Location:

Control unit: to be installed near the reversing light in the trunk
Warning unit: to be installed in a corner near the dashboard
Detection unit: sensors to be installed in the bumper.
6.3. Installation Procedure (fig. 9):
First determine where to install the control and warning unit according to the type of vehicle or your experience. Make
sure the power cable of the control unit can be connected easily.
For the installation of the sensors read "Tips for sensor Installation".
If the sensors are marked with 1, 2, 3, 4, just connect them to the sockets of the control unit bearing the same marks.
Refer to the connection diagram below.
SPBS4
6 VELLEMAN