Publicidad
Idiomas disponibles
Idiomas disponibles
4. Insert pipe into machine from the rear as shown
below.
5. Secure the pipe by turning the hammer chucks
clockwise until tight.
6. Place cutting wheel on pipe ensuring the cutting
wheel assembly does not come into contact with
the hammer chucks.
7. Press the arming button to arm system.
8. Select direction and speed.
9. Push foot switch to rotate pipe.
10. To stop the machine, release pedal on the foot
switch.
11.Using reamer:
a. Put the reamer down and use the carriage as-
sembly adjuster to slide reamer closer to pipe .
b. Using the carriage assembly adjuster, slide the
reamer away and lift reamer up to open position.
Hammer chucks
12.Using die head:
a. Set the die head down into position aligning
the height adjustment screw on the carriage
assembly.
b. Using the carriage assembly adjuster, slide the
die head applying pressure until the threads
engage on the pipe.
c. The machine will release the die head from the
pipe. Use caution and keep body away from
die release lever when dies release. Twist the
carriage assembly adjuster removing the die
head away from the pipe.
Do NOT attempt to use carriage
WARNING
assembly adjuster to remove pipe
from the die head while threading. Release the
pedal on the foot switch and wait until the ma-
chine comes to a complete stop to remove pipe
from threading.
d. Lift the die head to open position. Use caution
threaded pipe will be sharp.
10
Publicidad
