MOTOR
SAFETY FILTER
WARNING
Electrical Shock Hazard
Unplug power cord from electrical outlet.
Do not operate the vacuum cleaner
without the motor safety filter.
Be sure
the filter is dry and properly installed to
prevent motor failure and/or electrical
shock.
Check
motor
safety
filter
frequently
and
clean when dirty.
Remove the dust bag as outlined in the
CHANGING DUST BAG section. (Page 15)
Lift the filter cover
/
door located
at
|
the bottom
of the
dust container
and
check the filter
(see illustration), if
the filter
is dirty,
remove it by
\
pulling it toward
/_
you out of the dust
Filter Cover-
container.
Motor Safety Fiffer
Wash the filter in warm soapy water, rinse
and dry thoroughly
by squeezing the excess
water out of the filter
and allowing to air
dry for 24 hours
DO NOT wash in the dishwasher.
DO NOT install damp.
Replace the filter
by raising the filter cover
door and placing it in the slots provided
and slide it to the back of the dust
compartment
until it is in place. Close the
filter cover door.
Replace the dust bag as outlined in the
CHANGING DUST BAG section.(Page 15)
=16 =