Publicidad
Idiomas disponibles
Idiomas disponibles
Oasis 6T
Packing List
speaker
Important
Audibax has made every effort to provide accurate and detailed instruction for this
product's assembly. Should you have any doubts, consult a qualified professional
fitter, Audibax recognizes no liability for any difficulty or problem derived from the
interpretation of these instructions. These brackets and all their parts and accessories
must only be used for the purpose they have been constructed.
Audibax, its commercial distributors and retailers are not, directly or indirectly,
responsible for any damage to persons and or properties derived from the use of this
product in an unsafe or different way for which it has been designed and construc-
ted. Several parts of this product are small pieces of hardware therefore extreme
care should be taken to keep them from children.
Read These Instructions Carefully Before Using the Product
1. Place the speaker on a level surface.
2. Do not touch or bump the woofer and tweeter. Any damage will lead to sound
distortion.
3. Do not listen to sound at a very high level when you are changing the input source
(for example, to tune FM / CD) installation or removal of cables should make sure
that the power amp / amplifier device radio is turned off.
4. Don't attempt to clean the speakers with chemical solvents as this may damage
the paint surface. Clean only with a dry cloth.
Direct Burial Wire or Conduit
Depending on the type of installation, direct burial of the speaker wires from the
amplifier to the loudspeakers may be adequate, or the use of 1"-1-1/2" ID conduit
may be required for protecting the wires from possible physical damage if future
excavation or other alterations are anticipated in the area of the installation.
1
user manual
Connections Can be Protected Using One of the Following Methods
- Solder wires together using waterproof heat shrink tubing to seal.
- Use waterproof wire connectors.
- Make connections with immersion-resistant crimp splices.
- Use grease wire caps.
Connection
Use wire on the back of the speaker in the output tab of the amplifier (or amplifiers of
radio). The speaker wire is on one side red and on the other one black. Connect to
the red side of the amplifier and speakers (+) tab. Connect one end of the black side
(-) in the other tab. Connect each speaker to make sure that is not (+,-) inverted
polarity. If the polarity of the speakers is reversed, the sound will be unnatural and
will play without bass.
Anti-theft bracket
Underpowering Vs. Overpowering
1. Most speaker damage is caused by amplifiers with too little power (wattage).
2. An overdriven amplifier clips the waveforms and sends distortion to the speakers.
3.Clipping is usually audible; it may vary from a harsh sound to a fuzzy or unclear
sound.
4 If you hear the clipping at high volume levels, turn down the volume until the
distortion is gone.
5. Damage caused by operating the speakers at distorted volume levels is not
covered by the warranty.
Red Wire
Signal Feed from
Amplifier
installation panel
USER´S
MANUAL
Black Wire
To Next Speaker
Loudspeaker
Switch
Input
2
Publicidad
