Descargar Imprimir esta página

Flama 2366FL Manual De Instrucciones página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

RECOMMENDATIONS
The electrical installation of the part, the
installation of the device and its use must
comply with the regulations in force in your
country.
Do not use the device near flammable
objects and products, and, in general,
respect the minimum distance of 50 cm
between the device and other objects
(walls, curtains, mists, etc.).
The appliance must be placed so that the
electrical plug is accessible.
Do not pull on the power cord or the
appliance, even when you want to
disconnect the plug from the socket.
Never use the appliance leaning or lying on
its side.
This product is intended for domestic
use only. In the event of professional,
inappropriate use or use that does
not comply with the instructions, the
manufacturer declines all responsibility and
the guarantee will be void.
Fully unwind the cable before each use.
Do not use an extension cord not adapted
to the power of the appliance.
Do not switch on the appliance in a dusty
place or where there is a risk of fire.
DESCRIPTION
1. Lighted indicator
2. Thermostat control knob
3. Power level selector
4. Cord wrap
5. Heating elements
6. Feet with caster wheels
ASSEMBLING THE WHEELS
Turn the radiator upside down on a safe
and stable surface to avoid damaging the
paint finish or the floor covering.
Place the wheeled feet on the radiator,
placing the screws in a U shape between
the most external elements on each end of
the radiator.
Firmly tighten the wheeled feet on the
radiator, screwing the washers onto the
screws.
Note: only for model 2357FL (7 elements),
adjust the front set of wheels on the lower
part of the front panel with two screws, the
other wheels are similar to those described
above.
WARNING: only operate the appliance
in the normal, vertical position, with the
feet with the caster wheels mounted to
the lower part (wheels on the lower part,
controls on the upper part), any other
position can create a dangerous situation.
OPERATING INSTRUCTIONS
Turning on and adjusting the
radiator
Place the radiator in an upright position on
a horizontal, stable, heat-resistant surface.
Make sure that there are no flammable
products within a radius of at least one
meter. Using the radiator in any other
position can cause danger.
Turn
the
clockwise to the MIN position and the
power selector to the 0 position.
Unwind the power cord and connect the
radiator to the mains.
English
thermostat
regulator
anti-
15

Publicidad

loading