Publicidad
Idiomas disponibles
Idiomas disponibles
If running difficulties continue, contact your closest Authorized Dealer or Service Centre.
TRANSPORTATION AND STORAGE
Transportation
• Keep product and equipment safe and in a dry
and frost-proof area during transportation to
prevent damage and accidents.
• Empty the fuel and clean the product.
• Replace or repair damaged components.
• Use the correct protective cover on the product
that does not keep moisture.
• Keep the product tightly attached during transport.
Storage
WARNING: When draining fuel, please be
careful not to spill it. If fuel is spilt, wipe off
thoroughly. In addition, please be sure to
close the storage container cap tightly.
CAUTION: If fuel is left in the engine for
protracted periods, the inside of the
carburetor may become clogged and cause
engine faulty starting and insufficient output.
There is an air leakage at the
hose connector.
The strainer is clogged.
The strainer is damaged.
The level difference of the hoses
is too high.
The hoses are damaged or too
long.
The hoses has an incorrect
diameter.
Replace the sealing washer if it is damaged.
Tighten the hose connector and hose clamp.
Clean the strainer.
Replace the strainer.
Change the location of the product and/or the
hoses.
Replace and select the correct hose for the
operation.
Select the correct hose for the operation.
• On completion of all work procedures with no plan
to use the product for a protracted period, please
do the following pre-storage care to prevent
trouble caused by time-lapse changes.
1. Clean the suction filter and wipe off all the
unwanted stuff that attached.
2. Remove dirt from the product and check for any
damage or looseness. If any abnormality is found,
correct it thoroughly in preparation for future use of
the unit.
3. Drain the fuel tank.
4. Start the engine, and leave it at idle speed until
all the fuel in the carburetor is consumed and the
engine comes to a natural stop.
5. Remove spark plug and put a few drops (1 to 2
cc) of 2-cycle oil into the engine. After pulling the
starter rope 2 or 3 times, return the spark plug to its
original position and stop in compressed position.
6. After oiling the throttle trigger and other metal
parts with anti-corrosive oil, cover the product and
store indoors in a low-humidity location.
13
Publicidad
