Publicidad
Idiomas disponibles
Idiomas disponibles
Before performing cleaning, adjusting, repairing and
maintenance tasks, always unplug the power cord.
Replace worn out or damaged parts immediately, so that
the power tool is always in a safe operating condition.
Cleaning:
The power tool should be fully cleaned thoroughly after
use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out; all other works must be
performed by an official distributor.
If components or safety devices are removed for
maintenance purposes, they must be repositioned correctly
and immediately.
Maintenance of double insulated tools requires extreme
care and knowledge of the whole system and should only
be carried out by a qualified technician. Replacement of
components of a double insulated power tool should be
carried out with the same parts as the originals.
Use only VITO-approved accessories for this appliance or
technically identical parts. Failure to do so may result in
personal injuries or damages to the wet and dry vacuum
cleaner. If in doubt, if you lack knowledge or resources, you
should contact an official distributor.
Your wet and dry vacuum cleaner should only be serviced
by the manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts.
Fixed wheels
1. Place the wheel on shaft;
2. Insert the pin into the shaft hole;
3. Bend the ends of the pin;
4. Place the wheel cover.
Castor wheels
1. Insert the wheel fixing pin into the hole;
2. Place the washer and locknut on the pin;
3. Tighten the nut to secure the wheel.
When operating a vacuum cleaner, especially when dust is
vacuumed, static electricity is produced. Therefore, always
keep the anti-static chain, placed on the base of the
appliance and in contact with the floor.
1. Tighten the anti-static chain bolt (1) on the base of the
vacuum cleaner.
1. Insert the suction hose (11) into the adaptor (14) and
turn it clockwise;
2. Check that the hose is properly fixed;
Check that the hose is properly fixed:
3. Turn the hose adaptor counter clockwise and remove the
hose.
1. Insert one of the suction tubes (13) into the other;
2. Insert the lower end of the two coupled tubes into one of
the floor suction accessories.
Publicidad
