ARENDO 305868 Manual Del Usuario página 34

• If water is still left in the freezer unit, press the ice tray back carefully so
that all the water flows back into the water tank.
• To drain excess water, place the appliance with the front side on an edge
and place a bucket underneath, or place the appliance over a sink. Now
pull out the drain plug on the bottom of the appliance. Caution! Please
note: Once the plug is removed, water flows out of the water tank!
• Remove the ice collector.
• Clean the inside of the appliance using a soft cloth dipped in warm water
and vinegar. Then rinse it with clean water and allow it to dry completely.
• Replace the drain plug in the correct position. Wash the ice collector in
warm, soapy water. Rinse and dry it afterwards.
• Clean the outside of the appliance with a soft, slightly moist cloth. Use a
mild dish washing detergent if necessary.
NOTE: Do not use any organic solvents, boiling water, cleaning agents, strong
acids and bases, etc., for cleaning.
• Please empty the water tank and dry it for storage if the ice maker is not
used for long durations.
8. Troubleshooting
Error
" " LED
lights up
" " LED
lights up
34
Cause
• Low water level
• Inlet is blocked or
clogged
• Pump is faulty
• Ice collector is full
and the light barrier is
blocked
• Light barrier is faulty
Troubleshooting
• Fill the water tank
• Clean the inlet
• Please contact our Customer
service department
• Empty the collector
• Check the light barrier
• Clean the infrared LEDs of
the light barrier
English