Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 8: Carefully hold the iron over a sink, making sure that the power
supply cord and plug are kept away from the stainless steel soleplate
ES
and remain dry.
STEP 9: Press and hold the steam control switch in the self-clean
position. Hot water and steam will expel from the steam holes along
PT
with any impurities.
STEP 10: After approx. 1 minute or when the water tank is completely
empty, slide the steam control switch back into the off position.
EN
STEP 11: Set down the iron onto the heel rest and allow to cool
thoroughly.
STEP 12: When the iron has sufficiently cooled, wipe it with a soft,
FR
damp cloth.
STEP 13: Plug in and switch on the iron at the mains power supply.
STEP 14: Set the temperature control dial to the highest heat setting
STEP 15: Once the temperature indicator light has switched off, use the
iron on an old piece of fabric to remove any excess water and impurity
build-up from in the steam holes.
Note: Water may be ejected from the steam holes whilst the iron is
heating up.
Caution: Never slide the steam control switch to the self. clean
position when using the iron; only use it when the iron is switched
off and unplugged from the mains power supply and is safely held
over a sink.
Caution: When the iron is self-cleaning lots of hot steam will be
released from the steam holes of the iron.
HINTS AND TIPS
1. Always start ironing on a low heat setting and work up to a higher
one, if necessary; it takes less time for the iron to heat up than it does
to cool down.
2. The temperature of the iron is hottest when it has initially heated up
and will therefore need time to stabilise. Once the iron has heated up,
allow the temperature indicator light to cycle off and on again before
using the iron.
3. Before each use, check the care labels on the fabrics to be ironed so
that the correct temperature is selected.
STORAGE
Check that the iron is cool and dry and that the water tank is empty
before storing in a cool, dry place.
Instruction manual
Wrap the cord loosely around the iron; never wrap it tightly as this could
cause damage.
TROUBLESHOOTING
Warning: To reduce the risk of fire, electric shock or injury, switch off
and unplug the iron from the mains power supply before troubleshooting.
Problem
Reduced constant
steam or no
constant steam.
The fabric shows
signs of melting.
The iron will not
turn on.
Water does not
spray out of the
spray nozzle.
The iron is not
removing the
creases from the
fabric.
ref. 07713
Posible Cause
Posible Solution
Clear the steam holes of
any blockages following the
The steam holes are blocked. The
instructions in 'Care and
steam control switch is set to the
Maintenance'. Select a steam
off position.
setting using the steam control
switch.
The temperature selected is
Reduce the temperature using
too high
the temperature control dial.
The iron is not connected to the
Plug in and switch on the iron at
mains power supply.
the mains power supply.
Fill the water tank following
the instructions in the section
I There is no water in the water
entitled 'Filling the Water Tank'
tank The iron is being used for
Press the water spray button
the first time.
several times until water is
released from the spray nozzle.
Increase the temperature using
the temperature control dial,
The temperature is set too low.
making sure that the fabric's care
The steam control switch is set
instructions are followed. Select
to the off position.
a steam setting using the steam
control switch.
Publicidad
