Publicidad
Idiomas disponibles
Idiomas disponibles
m) Fence lines powered by separate fence energizers should be installed with
sufficient distance (at least 2 meters) between them to prevent simultaneous
user contact with both fence lines. Simultaneous contact of two fences
powered by separate energizers can be dangerous.
n)
Never connect barbed wire or similar types of fencing to the unit where an
animal or human may become entangled or caught. This carries a risk of death.
o)
Never place your head or neck near a live fence. This accidental contact can
often occur when testing voltage or when installing ground rods.
p)
Ensure that proper circuit breakers are installed and used in areas where
maintenance is to be performed.
q)
Never touch or attempt to climb over an operating fence, as this carries a risk
of electric shock.
r)
Use extreme caution during installation and make sure that children, animals,
or persons unaware of the danger are not near the fence.
s)
Inform all employees and others who may come in contact with the fence
about the operation of the fence and how to disconnect it if necessary.
t)
Periodically check the electrical performance of the fence with appropriate
measuring equipment.
u)
The device must be properly grounded.
v)
Do not use the unit near flammable materials, including gasoline, kerosene,
and cleaning fluids.
w)
Wear electrical insulating clothing when installing the unit.
x)
Install an adequate number of warning signs on the live fence so that they are
clearly visible. Unless the law in the area where the equipment is used says
otherwise, the following guidelines should be followed:
• Warning signs should be placed in conspicuous locations on all fences at
intervals not exceeding 10 meters. These signs must face the outside of the
fence.
• Where access to the fence is possible from the inside, warning signs should
be placed on both sides of the fence.
• Warning
If children are likely to be around the fence, warning signs should also be
placed at a height of 0.8 meters (80cm).
• Where an electric fence crosses a public path, an electrically de-energized
gate shall be installed in the fence.
• All warning signs must be at least 200 mm x 100 mm and painted yellow
with black text.
y)
When connecting the battery, be careful not to short out the power terminals.
z)
The product does not have an ON/OFF switch, this means that there is voltage
at the terminals of the device when it is connected to the power supply.
aa) Do not touch the unit with wet or damp hands.
bb) In spite of the applied casing tightness class, protecting the the device
additionally against precipitation, especially rain, is recommended.
signs
should
be
1.5
meters
(150cm)
high.
Publicidad
