Publicidad
Idiomas disponibles
Idiomas disponibles
How to Set the machine.
Press
button in 3 second, You will found
open or close the Beam light. Continue Press
CAL. Adjust the error value. From -7mm to 7mm
BP.
On or off the buzzer
BL.
On or off the backlight
Od. On or off the outdoor type.
How to set the Reference edge
Press
button to choose the position from which measurement is to be taken from the bottom or
from the top of the device.
How to set the Unit (mm/inch/ft)
Press
3 second you can change the unit from
mm / inch/ ft , The device will remember the last displayed unit.
Battery status symbol
When the three segment codes in the battery boxes all display, it indicates that the battery
level is relatively full.
The fewer segment codes displayed the lower battery level. When the boxes are empty, the
battery should be replaced.
Clear function
Press
button it will be clear the measuring result of a single measurement (area or volume)
with same function in order to go to the next measurement.
How to set the backlight
Press
button in 2 second, You will turn on or turn off the backlight of display.
Signal strength symbol
When the five signals symbol
The fewer signal symbol means the weaker measuring signal strength.
5. MEASUREMENT
Signal measurement
When the laser light is off, Press
working. Press
again you can got the measure. The device will save the normal measuring result
automatically.
Continuous measurement
Press
button to turn on the laser light. And press
start continuous measurement. If you want to stop continuous measurement, stop pressing the
is flickering, Press
button you choice to set the following function.
all displays, it means that the measuring signal strength is high.
button will be turn on the laser light. Then the device will be
4
button you can set
button in 3 second, The device will be
Publicidad
