Klark Teknik GRAP-TMP-00065 Guia De Inicio Rapido

Quick Start Guide
VNET INTERFACE RACK MOUNT
RACKING
To mount an Accessory in the Mounting Kit panel:
(1) Remove the two mounting brackets and blanking sheet from the
aperture in which you would like to install the accessory. Remove the two
nuts to disassemble the pieces, but keep the nuts, screws and washers
for reassembly.
(2) Remove the two screws from one side of the accessory.
(3) Using the two screws removed in step 2, attach one mounting bracket
loosely to the side of the accessory with the 'ear' towards the front,
pointing outwards.
(4) Repeat 2 and 3 for the other side. Push the lid towards the back of the
unit as far as it will go, then align the bracket ears with the front edge
of the lid. Tighten the screws to secure.
V 1.0
GRAP-TMP-00065
(5) Offer the accessory with its mounting brackets up to the reverse side of
the Mounting Panel, and fix it in place using the two sets of screws,
washers and nuts removed in step 1.
Note that the holes at the rear ends of the brackets may be used as cable tie-off
points if desired.
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss which may be suffered by any person who
relies either wholly or in part upon any description, photograph, or statement contained
herein. Technical specifications, appearances and other information are subject to change
without notice. All trademarks are the property of their respective owners. Midas,
Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer,
Bugera, Oberheim, Auratone, Aston Microphones and Coolaudio are trademarks or
registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd.
2021 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding
Music Tribe' s Limited Warranty, please see complete details online at musictribe.com/
warranty.