smartmi P2 Manual De Usuario página 4

Installation
2 0 c m
o r m o
r e
2 0 c m
o r m o
r e
Placement To allow the purifier to operate as effectively as
possible, maintain a suitable distance between
its air inlet and obstructions such as walls (see
figure above).
Note: For optimal air purification, keep doors and windows
closed during use.
05
Connect Connect power adapter to the
the power
power port at the bottom of the
supply
main unit. Then connect the power
adapter to a power socket.
Use
Power on/ Standby Switching mode
Touch the Power on/ Standby When the device is turned on,
Button to turn it on. touch the Mode Button to cycle
In the power-on state, touch through operating modes.
the Power on/ Standby Button
to turn it off.
Battery level indication and charging
Timing
Connected to a power supply
When the device is turned on,
After the purifier has been
touch the Timing Button to cycle
connected to the power
through "1h-2h-4h-8h-cancel"
supply, the screen will be as
and start the timer. The device will shown in the figure on the
right and then return to the
automatically switch to Standby
main interface or shut off.
after the timer has run out.
Fully charged
When the purifier is fully
charged, the screen will be
as shown in the figure on the
right and then return to the
main interface or shut off.
Battery powered
When the power is cut off
after the device has been
turned on, the screen will be as
shown in the figure on the right
Prompt: The main interface will display the time
and then return to the main
remaining after it has been set.
interface.
06
Adjust the display brightness/
night light.
When the device is turned on,
touch the Brightness Button to
cycle through the options for
screen brightness (full brightness,
half brightness, and off). Press and
hold the Brightness Button for 3s to
dim the night light. Press and hold
for another 3s to gradually turn up
the night light.
Prompt: Adjust the night light
RGB color in the app
Turn battery power off/on
Press and hold the Brightness Button and
the Power on/ Standby Button at the same
time for 5s. The battery power can be turned
off/on after the purifier has beeped.
Prompt: When powered on, the device
uses the power adapter to supply power
and charge the battery; when the device
is unplugged, the battery is automatically
activated. The whole device switches off
after the battery power has been used up.