Unpacking And Assembly - Optica B-1000 Manual De Instrucciones

2.0 UNPACKING AND ASSEMBLY

2.1 The microscope is housed in a moulded Styrofoam container. Remove the tape from the edge of the
container and lift the top half of the container. Take some care to avoid that the optical items (objecti-
ves and eyepieces) fall out and get damaged. Using both hands (one around the arm and one around
the base), lift the microscope from the container and put it on a stable desk.
2.2 The objectives are already mounted on the nosepiece or located in individual protective vials (depen-
ding on the model). Remove the objectives from the vials and insert them into the microscope nose-
piece in the order from the lowest magnification to the highest.
2.3
Place the brightness sensor attachment onto the top of the arm and tighten the lock-screw with the
provided wrench. The sensor connector must face the rear of the microscope. Connect the attach-
ment with the provided cable to the socket on the side of the arm.
2.4 Place the observation head onto the top of the attachment and tighten the lock-screw with the provi-
ded wrench. Insert the eyepieces into the eye tubes.
Connect the cable from the provided external power supply into the socket on the back of the base.
The power supply should be used only on network sockets equipped with adequate grounding.
Once positioned and installed with the necessary components, the microscope is ready to be used.
Your microscope is a laboratory instrument designed to last. Handle it always carefully and avoid
abrupt vibrations or shocks. Always disconnect the power supply from the wall socket when not in use
for long time, while you clean it or when you perform any maintenance.
AVOID DISASSEMBLING THE INSTRUMENT
Do not disassemble the instrument. This entails the cancellation of the warranty and may cause mal-
function.
Page 7