Publicidad
Idiomas disponibles
Idiomas disponibles
Safety warnings
Repairs by a
qualified
electrician only
This electric power tool
complies with the relevant
safety regulations. Repairs
should only be performed
by a qualified electrician.
Otherwise the user may
run the risk of accidents.
If this tool's main power
Important advice
L Do not use liquid or pasty adhesives!
L The glue reaches temperatures of up
to 200 degrees Celsius! You could burn
yourself!
L You could burn yourself. After skin
contact with hot glue: immediately cool
with cold water. Do not try to remove
hot-melt glue from the skin. If necessary,
seek medical attention. After eye contact
with hot-melt glue: immediately cool for
approx. 15 min. with running water and
consult a doctor straight away.
L The area you are gluing must be free of
grease, dry and absolutely clean.
L Glue marks on clothing cannot be
removed.
cord is damaged, it must
be replaced by the ma-
nufacturer or its customer
service department or a
similarly qualified person
so as to avoid hazards.
Keep these safety
precautions with the
tool.
L Make sure heat-sensitive materials are
suitable for gluing
L Drips of glue are best removed when
cold.
L Do not pull the glue stick out of the
applicator. Hot glue running into the
applicator may cause damage.
L Do not use in conjunction with highly
inflammable/combustible materials.
L Adhesive joints and glued areas can be
painted or varnished over and can be
taken apart again by heating them
L GlueMatic 3011 only:
Always screw the nozzle tight after re-
placing it (approx. 1 Nm).
L Proper operation is only guaranteed
by using genuine STEINEL sticks.
- 13 -
Publicidad
