Publicidad
Idiomas disponibles
Idiomas disponibles
3. Add defoamer to clean water tank as needed.
4. Plug power cable into outlet.
WARNING: Ensure machine is properly
grounded.
5. Press the VACUUM switch to the on position.
6. Press the PUMP and BRUSH switches to the on position.
7.
Push the brush lowering pedal forward to lower
carpet brush. Push down and back to raise brush.
(See Figure 1)
8. Press and hold solution switch to apply the cleaning
solution. Simultaneously pull the machine backward
to clean. Release the solution spray button about 12"
before the end of run. (See Figure 2)
Figure 2
Solution Switch
NOTE: Slightly overlap the next cleaning pass to
prevent streaking.
NOTE: A two wet pass maximum is
recommended to avoid overwetting.
PAGE 3 OF 12
OPERATION CONTINUED
Drain Hose
Brush Lowering Pedal
Figure 1
IMPORTANT! After a few passes, check the
waste tank to see that no foam is present.
Add extra defoamer if necessary.
9. Empty recovery tank when it is approximately 3/4 full.
IMPORTANT! Do not refill the solution tank
without emptying all contents of the recovery
tank first.
STORAGE
When cleaning is finished:
1.
Empty the recovery tank using the drain hose. Rinse
recovery tank when empty.
2. Attach quick connect hose to solution hose fitting.
(See Figure 3)
Figure 3
Recovery Hose
Connector
Solution Hose
Fitting
3. Turn the PUMP switch on to drain the solution tank.
4. To disconnect solution hose, push locking ring and
pull hose off fitting. (See Figure 4)
Figure 4
Solution Hose Ring
5. Empty and leave recovery tank open when storing.
6. Leave brush raised for storage.
0323 IH-10420
Publicidad
