Publicidad
Idiomas disponibles
Idiomas disponibles
5. Start playing audio
Turn on your audio device if it's not already turned on. For variable volume sources (ones
with volume adjustment), make sure the volume is around 50%. Then start playing audio on
your device.
The cradle/transmitter's red POWER indicator lights up as soon as it's powered and senses
an incoming audio signal.
6. Turn on the headphones
Put the ON/OFF switch on the headphones in the ON position. Make sure the headphones
are not too loud! (Use the volume dial on the headphones to adjust headphone volume.)
Then put the headphones on and enjoy!
If you hear interference, press the AUTO TUNE button on the headphones (the indicator
light next to the AUTO TUNE button comes on).
For best results, try auto tuning the headphones at a distance of around 20 feet (7 meters)
from the cradle/transmitter.
If you don't notice an improvement after several attempts at auto tuning, try changing the
channel setting on the back of the transmitter. Then press the AUTO TUNE button on the
headphones to find the new channel.
Note: The transmitter automatically switches off after approximately four minutes without
an audio signal (or if the audio signal that it receives from the audio source is too weak
for proper reception). Once the signal returns to an acceptable level, then the transmitter
automatically switches on again.
4
Publicidad
