Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
NO SOUND
•
Make sure the cradle/transmitter's power adapter is plugged into your outlet
properly, and that the other end of the adapter is properly connected to the
DC IN connector on the cradle/transmitter.
•
Make sure the cradle/receiver and headphones ON/OFF switches are both
switched to ON.
•
The headphones' battery charge level might be too low. Place the
headphones on the cradle/transmitter to recharge them.
•
Make sure your audio source is turned on and not muted.
•
Use the headphones' volume control to increase their volume.
•
Make sure your audio source is playing something with audio. Make sure the
audio source is turned up loud enough that the cradle/transmitter's POWER
indicator turns red.
•
Make sure the audio cable from the cradle/transmitter is connected properly
to your audio source's audio output jack(s).
DISTORTION
•
Make sure the headphones' indicator light next to ON/OFF switch is
illuminated. If not, press AUTO TUNE on the headphones until it lights.
•
Use the channel selector on the back of the cradle/transmitter to change
the transmitter's transmission frequency. Then press the headphones' AUTO
TUNE button to retune to the new frequency.
•
The headphones' battery charge level may be too low. Place the headphones
on the cradle/transmitter to recharge them.
•
Turn the headphones down.
•
The headphones might be too far away from the cradle/transmitter. Move
closer to cradle/transmitter.
•
The audio signal input level from your audio device might be too low.
Increase its volume.
5
Publicidad
