eufy Security Video Doorbell 2K Guia De Inicio Rapido página 9

STEP 6 CONNECTING THE WIRES
Connect the Wires
Connect the wires to the two terminals at the back of the doorbell, then tighten the terminal
screws. Wire can connect to any terminal.
• To prevent short-circuit, make sure the wires are not touching each other or
crossing after connecting them to the terminals.
What is required: Power Adapter / Video doorbell / Philips-Head Screwdriver
Power Adapter
13 English
Video Doorbell 2K (Wired) Phillips-Head Screwdriver
Model: T8200 (User provides it.)
STEP 7 HOOKING / DETACHING THE
DOORBELL
Hook the Doorbell on the Mounting Bracket
There are 2 thermal conductive pads on the mounting bracket. They're used to conduct heat from
the video doorbell to the metal bracket.
1.
2. Hook the doorbell on top of the mounting bracket.
3. Snap the doorbell bottom to the bracket and press it down until it clicks into place.
1
the doorbell.
2 3
English 14