BRÖTJE SIS 3 SGB Instrucciones De Montaje página 12

en
1 Safety
1 Safety
1.1 General safety instructions
1.2 Recommendations
12
Caution
There is a risk of significant material damage
when installing the accessories. Accessories
must therefore only be installed by trained
contractors and commissioned by a competent
person appointed by the system installer.
Accessories used must correspond to the
technical regulations and be approved by the
manufacturer in combination with these
accessories.
Caution
Only genuine spare parts may be used.
Danger
Risk of death due to modifications to the boiler!
Unauthorised conversions and modifications to
the boiler are not permitted, as these can put
people at risk and cause damage to the boiler.
Failure to comply with these instructions renders
the approval for the boiler void.
The safety set SIS 3 SGB is used to secure heating
systems with gas condensing boilers of the series
Eurocondense 400 kW - 610 kW against overpressure
with a boiler output over 300 kW corresponding to DIN
12828.
Important
When using the safety set SIS 3 SG the
installation of a flash tank or the installatin of a
low water protection can be omitted since it
incluedes two maximum pressure limiters. The
prerequisite is that a working pressure of 3 bar is
not exceeded.
7309871 - 03 - 20022020