Publicidad
Idiomas disponibles
Idiomas disponibles
8. Do not assume neutral ar ground wire is safe to touch. lncorrect or poorly connected circuits
may cause wires to be charged.
9. When low battery indication appears, please replace the batteries.
10. When using the detector, please only hold up to the line befare the translucent sensing part
and not over.
11. Comply with local and national safety regulations and requirements.
12. The detector will not detect any voltage if:
- The wire is shielded.
- The operator is not connected with the ground ar isolated from an effective ground.
- The voltage is DC.
13. The detector may not detect any voltage if:
- The operator does not hold the detector.
- The operator is wearing gloves.
- The wire under test is partially buried ar in a grounded metal conduit.
- The magnetic field generated by the voltage source is blocked, suppressed or interfered
with.
- The frequency of the voltage being detected is nota perfect sine wave and may be distorted
by harmonics.
- The detector is used outside of the operating specifications (see Technical Specifications far
details).
lt is applicable to test and measuring circuits connected at the source of the
CAT IV
ELECTRICAL SYMBOLS
Protected throughout by Double insulation ar Reinforced insulation
Caution, possibility of electric shock
Warning! Refer to the manual
In compliance with the directive of European Union
Conforms to UL STD 61010-1, 61010-2-030
Certified to CSASTD C22.2 No. 61010-1, 61010-2-030
building's low-voltage MAINS installation
Alternating current
7
Publicidad
