Uline H-10467 Manual De Instrucciones página 2

BEFORE FIRST USE
1. Carefully remove the retaining clip attached to the
handle socket. (See Figure 1)
CAUTION! The socket will tend to spring upward
when the clip is removed. To prevent possible
injury, place one hand on top of the handle
socket to control the upward motion of the
handle socket retaining clip, then carefully
remove the retaining clip. After removing,
slowly allow the handle socket to rise back into
the resting position.
Figure 1
2. Press the quick disconnect button on handle
piece 2 and insert into handle piece 1. The quick
disconnect will automatically pop out when the hole
position is aligned with the quick disconnect button.
(See Figure 2)
Figure 2
Handle
Piece 1
PAGE 2 OF 21
Handle Clip
Socket
Handle
Piece 2
Quick
Disconnect
ASSEMBLY
3. Loosen the handle socket screw to insert the
assembled handle. (See Figure 3)
Figure 3
4. Place handle into handle socket. Align the square
hole located at the bottom of the handle over the
square bolt inside the handle socket. (See Figure 4)
Figure 4
5. Secure the handle in place by tightening the handle
socket screw. (See Figure 5)
Figure 5
Handle
Handle
Socket Screw
1222 IH-10467