Faults - DÜPERTHAL CLASSIC Serie Manual De Instrucciones

Faults

10

Faults

Fault description Cause
Doors do not Safety storage cabinet
close. is not aligned correctly.
Doors are held open
by objects.
Safety storage cabinet
is not correctly filled.
No extractor pre- Venting cut-off flaps
sent. closed, as closing
mechanism has been
triggered.
Doors do not Moving parts, such as
move easily. hinges, are dirty or cor-
roded.
Doors open Safety storage cabinet
again after is not aligned correctly.
being closed.
Doors close Safety storage cabinet
again after is not aligned correctly.
being opened.
Remedy
Install the safety storage cabinet so it is hori-
zontal. Ä Chapter 6.4 'Check the alignment of
the safety storage cabinet' on page 99
Do not wedge or hold doors open with any
objects.
Make sure that containers in the safety storage
cabinet are uniformly distributed.
Replace the locking mechanism.
Remove rust.
n
Lubricate parts.
n
Remove corrosive substances from the
n
safety storage cabinet.
Notify technical customer service.
n
Unscrew the front adjustable feet slightly.
n
Align the safety storage cabinet so it is hor-
n
Ä Chapter 6.3 'Align the safety
izontal.
storage cabinet' on page 99
Unscrew the rear adjustable feet slightly.
n
Align the safety storage cabinet so it is hor-
n
Ä Chapter 6.3 'Align the safety
izontal.
storage cabinet' on page 99
Personnel
Technical specialist
employees
Technical specialist
employees
Technical specialist
employees
DÜPERTHAL service
technicians
Technical specialist
employees
Technical specialist
employees
Technical specialist
employees
CLASSIC line, COMPACT line 113