Publicidad
Idiomas disponibles
Idiomas disponibles
time for the tool to cool down before re-
charging to achieve the full charge.
2. TO REMOVE OR INSTALL THE BATTERY
PACK (SEE FIG. B)
Depress the battery pack release button to release and
slide the battery pack out from your tool. After recharge,
slide it back into your tool. A simple push and slight
pressure will be sufficient.
ASSEMBLY
1. ASSEMBLING THE BLOWER TUBE (SEE
FIG. C1, C2, C3)
Before assembling the blower tube, be sure the on/off
switch is in ''O'' off position.
Fit the blower tube to the motor housing as shown in Fig.
C1. Check the blower tube is firmly secured (See Fig. C2).
Fix the blower tube to the blower port with the screw
provided (See Fig. C3).
WARNING: Do not attempt to operate
or disable the on/off switch by any
means other than the normal assembly or
removal of the tube.
NOTE: Before disassembling the blower tube, be sure
the on/off switch is in ''O'' Off position. First loosen the
screw, as shown in Fig. C3. Press the tube release button,
so that you can separate the tube (See Fig. C4). Do not try
to separate the tubes by force or by using tools.
OPERATION
1. STARTING/STOPPING (SEE FIG. D)
Starting
Move the on/off switch to the "I" On position.
Stopping
Move the on/off switch to the "O" Off position.
WARNING: The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
2. USING THE BLOWER (SEE FIG. E)
The blower is intended for residential use only. Use the
blower outdoors to move debris from hard surfaces. This
blower is not designed to clear leaves from large grassy
areas, or move wet, heavy debris.
USER TIPS
- Hold the blow tube approx 180mm above the ground
when operating the tool.
14
- Use a sweeping motion from side to side. Advance
slowly keeping the accumulated debris/leaves in front of you.
- After blowing the debris/leaves into a pile, it is easy to
dispose of the pile.
CAUTION! - Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near bystanders or pets.
- Use extra care when cleaning debris from stairs or other
tight areas.
- Wear safety goggles or other suitable eye protection,
long pants, and shoes.
MAINTENANCE
1. Remove the battery pack before any work on the
device.
2. Store the tool, instruction manual and accessories
in a secure, dry place. In this way you will always
have the information ready.
3. Keep the tool's air vents unclogged and clean at
all times.
4. Remove dust and dirt regularly. Cleaning is best
done with a rag or brush.
5. Never use caustic agents to clean plastic parts.
CAUTION: Do not use cleaning agents to clean
the plastic parts of the tool. A mild detergent on a
damp cloth is recommended. Water must never come into
contact with the tool.
FOR BATTERY TOOLS
The ambient temperature range for use and storage of
tool and battery is between 0 °C and 45 °C.
The recommended ambient temperature range for the
charging station is between 0 °C and 40 °C.
TROUBLESHOOTING
Problem
Possible
cause
The tool
Low battery
does not
capacity
work
The battery
pack is not
fully inserted
The battery
The battery
pack
pack release
cannot be
button is not
removed
pressed
Fault
correction
Charging the battery
Insert the battery pack
to the end
Press the battery pack
release button
EN
Publicidad
