Publicidad
Idiomas disponibles
Idiomas disponibles
Softclima
5.
Operation
5.5.
Changing the bathing mode
The bathing mode can be changed during Sauna operation.
1.
Press the MODE button repeatedly, if necessary, until the operation mode Sauna or Softclima LED
illuminates.
.
A transition period of at least 20 minutes is necessary because of the different climatic conditions
of the two forms of bathing.
5.6.
Ending the Sauna mode
1.
Press MODE button repeatedly, if necessary, until the operation mode END LED illuminates.
.
The sauna heater switches Off.
2.
Switch Off the control system: Switch Off main switch on the left side of the control system.
.
The operation mode End LED goes out.
3.
After the bath, temporarily open the cabin door and leave it open to air out the cabin.
5.7.
Ending the Softclima mode
1.
Press MODE button repeatedly, if necessary, until the operation mode END LED illuminates.
.
The sauna heater is switched Off and the 25-minute-follow-up program starts. During the
follow-up program, the operation mode End LED flashes. As soon as the follow-up program has
ended, the operation mode End LED is permanently lit.
2.
Then switch Off the control system: Switch Off main switch on the left side of the control system.
.
The operation mode End LED goes out.
3.
Drain the cooled-off water from the water tank of the Softclima heater.
'
Draining residual water - see Section 5.9.
Danger of burns!
Drain the water only after the heater has cooled off.
4.
After the bath, temporarily open the cabin door and leave it open to air out the cabin.
5070145/05.09
PAGE 9
Publicidad
