Bromic Heating 3400W Manual De Instrucciones página 11

WIRING DIAGRAM FOR LOW CLEARANCE CEILING RECESS KIT
(FOR USE WITH DIMMER OR ON/OFF)
BELOW IS A SIMPLIFIED DIAGRAM OF THE TERMINAL BOX.
ALL CONNECTIONS ADJUSTED BY THE INSTALLER ARE DISPLAYED.
ITEMS NOT DISPLAYED SHALL NOT BE MODIFIED.
WARNING
AC Single Phase Heater
must be permanently
installed and hard wired
by an authorised/licensed
person.
This product is designed for use
with both 220-240V & 208V
Platinum Electric Heaters.
WIRES DENOTED
BY DASHED
LINES ARE
SUPPLIED BY
THE INSTALLER.
NOTES:
• For wiring instructions using Bromic SmartHeat Electric Wireless Dimmer BH3130011-1 or
ON/OFF Controller BH3130010-1 refer to the instructions provided with the controller.
• Connecting to a 3-phase power system can only be done for 208V versions of the
Platinum Electric Heater.
Non-self resetting
thermal switch
TOP VIEW OF
TERMINAL BOX
To Dimmer Power (Load) Output To
OR ON/OFF Power (Load) Output
To Dimmer Power Supply Input
To
OR ON/OFF Power Supply Input
S1
BROWN
LIVE/ACTIVE
HOT LEG 1
OR
OR PHASE A
PHASE B
OR
PHASE C
OR
bromic.com
S2
N2
L
N
SUPPLY
BLUE
GREEN/YELLOW
NEUTRAL
HOT LEG 2
PHASE B
PHASE C
PHASE A
HEATER
CABLE
EARTH
11