Getting started
Automatic Load Sensing
This determines the correct agitate profile, agitate duration and amount of water suited to the size and type of load placed in the
washer . The washer will not start the wash cycle or fill with water if the lid is open . When the lid is closed the machine is able to
begin filling with water in order to sense the load size .
NOTE: Automatic Load Sensing initiates a spin at the beginning of the cycle and will take as much as 3 minutes to complete
(significantly shorter for smaller loads); this is normal operation .
NOTE: This is a high efficiency washing machine . This system requires less water while providing effective cleaning action . You
may notice that the water level is lower than on your previous washer . This is normal .
Liquid Fabric Softener Dispenser
The agitator cap fits into the top of the agitator . If it accidentally
comes off, simply put it back on .
The fabric softener dispenser automatically releases liquid fabric
softener at the proper time during the cycle .
Do not stop the washer or raise the lid during the first spin.
This will cause the dispenser to empty too soon.
To use, follow these steps:
1
Make sure dispenser is securely attached to agitator .
Pretreatment
Place laundry pretreatments, such as an Oxi product, directly
in the bottom of the wash basket before loading clothes .
10
2
Use only liquid diluted fabric softener . Pour into dispenser,
using amount recommended on package .
Never pour fabric softener directly on clothes. It may stain
them.
3
Add water to dispenser until it reaches the maximum fill line .
Do not pour anything into the agitator
if the agitator cap or dispenser is
removed .
4
Select Deep Rinse option .
ONLY this
NOTE: Fabric softener may not dispense properly if the Deep
portion of the
Rinse option is not selected .
dispenser is
visible once
installed into
agitator
NOTE: Do not use liquid chlorine bleach and laundry
pretreatments such as an Oxi product in the same wash load .
49-3000336 Rev 0