Windgoo B3 Manual Del Usuario página 5

Product accessories Folding
x2 x1 x1 x1
Func�on Introduc�on:
1.charging: connect the charger to charge,with AC plug first and DC plug next.When
the power bar on bike handle shows full and the charger indicator turns green from
red, it indicates full power.
2.Power ON/OFF: Press the red power bu�on to turn ON/OFF the bike. The dash
board lights up a�er turning on and the dash board light will be off a�er turning
off the power.
3. A�er boo�ng, the dash board lights up and indicate the amount of electricity.
4.Horn: Pressing the horn bu�on to turn it on or off.
5. Front light : Push the light bu�on forward to ac�ve the front light, push back the
light bu�on to turn off the front light.
6. Brake and rear light: Back light lights up when braking.It could not accelerate
before the brake is fully loosened.
7. To start the scooter, first slide the scooter with your foot 1-2 meters, then press the
accelerator for running，then use your feet to get up to 5km/h and then use the
thro�le to accelerate. Press the thro�le lightly to accelerate the vehicle, and press it
harder the speed goes faster. The dash board will show the speed per hour.
8. Speeding : Please speed up slowly,don't force the rota�ng bar hard or it will be
broken.
9. Cruise: The ebike goes into cruise mode automa�cally a�er driving 8 seconds in
same speed. Brake or release the rota�ng bar and speed up again then the
uniform cruise mode is canceled.
10.Adjustable pole lock：adjust the seat height, then close the lock buckle.
5