Descargar Imprimir esta página

Kobalt KPS 1040B-03 Manual Del Usuario página 11

Podadora de altura sin escobillas

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
5. Before Using the Pole Saw:
Refer to "Safety Information" earlier in this manual for appropriate safety equipment.
DANGER
• Never cut near power lines, electric cords, or other electric sources. If the bar and
chain jams on any electrical cord or line, DO NOT TOUCH THE BAR, CHAIN OR THE
ALUMINUM POLE! THEY CAN BECOME ELECTRICALLY LIVE AND MAY BE VERY
DANGEROUS. Continue to hold the pole saw by the insulated handles or lay it down and
away from you in a safe manner. Disconnect the electrical service to the damaged line or
cord before attempting to free the bar and chain from the line or cord. Contact with the bar,
chain, other conductive parts of the pole saw, or live electric cords or lines will result in death
by electrocution or serious injury.
WARNING
• Do not use any attachments or accessories not recommended by the manufacturer of this
product. The use of attachments or accessories not recommended can result in serious
personal injury.
Before each use, inspect the entire product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced.
a. Remove the battery pack.
b. Make sure that the saw chain (D) is properly mounted and correctly tensioned.
c. Lift the tip of the guide bar (C) up to check for any sagging in the chain. If the tension
requires adjustment, refer to the section: "Replacing the Bar and Chain" in the
"Maintenance" section of this manual for adjustment instructions.
d. Check the oil level and fill the oil tank (F) as needed.
e. Check the cutting-teeth sharpness of the saw chain.
f.
Make sure that the chain is well lubricated.
g. Stand upright and hold the pole saw in a relaxed position.
h. Make sure the saw chain is not touching the ground or any other objects.
i.
Hold the pole saw with both hands: with the right hand on the rear handle (N) and the left
hand on the front handle (K).
j.
Make sure that you have a secure and balanced footing. Watch out for obstacles such as
tree stumps, roots, and ditches, which could cause you to trip or stumble.
11

Publicidad

loading

Este manual también es adecuado para:

3809900/4132855