Senix CSX2-M Manual Del Operador página 16

ASSEMBLY
1. Unpack all parts and lay them on a flat, stable surface:
2. Remove all packing materials and shipping devices, if
applicable.
3. The scope of delivery varies depending on the country
and purchased variant:
Model of CSX2-M-0
• Chainsaw x1
• Instruction manual x1
• Guide bar x1
• Guide bar cover x1
• Saw chain x1
4. If you find that parts are missing or show damage do
not use the product but contact your dealer. Using an
incomplete or damaged product represents a hazard to
people and property.
5. Ensure that you have all the accessories and tools
needed for assembly and operation. This also includes
suitable personal protective equipment.
NOTE:
CSX2-M includes the charger and the battery pack.
CSX2-M-0 does not include the charger and the battery
pack.
WARNING:
Wear protective gloves for this assembly work
and always lay the product on a flat and stable
surface while assembling.
Follow the assembly instructions step-by-step
and use the pictures provided as a visual guide
to easily assemble the product!
Do not insert the battery pack before the power
tool is completely assembled or adjusted!
INSTALLING THE SAW CHAIN
AND THE GUIDE BAR
WARNING:
Ensure the battery pack is removed from the
chainsaw before attaching the bar and chain.
1. Turn the side cover knob counterclockwise and remove
the side cover (Fig.2).
2. Loop the saw chain into the slot around the guide bar.
Make sure the saw chain is in correct running direction
by comparing saw chain with the rotation symbol (Fig.3).
3. Mount the chain and guide bar to the product. You may
need to preliminarily tension the chain by the tensioning
knob for fitting the chain around the drive sprocket.
EN - 16
4. Pull the chain around the bar with your gloved hand or
using auxiliary tools to make sure it can run smoothly
(Fig.4).
NOTE:
It is still recommended to check for smoothness of the saw
chain before operation even after using it for a period of
time.
6. Replace the side cover. Meanwhile, prevent the saw
chain and the guide bar from sliding out.
7. Lightly tighten the side cover with the side cover knob.
Do not tighten too much for further adjustment (Fig.3).
8. Adjust the tension with the tensioning knob until it can
be raised approx. 2–3 mm from the guide bar in the
centre (Fig.3).
9. Thoroughly tighten the side cover with the side cover
nut (Fig.3).
NOTE:
After a short period of use, allow the chain to cool, remove
the battery and check the tension again.
BAR AND CHAIN OIL FILLING
WARNING:
Bar and chain oil prevents premature wear.
Never operate the chainsaw if oil is not visible.
Check oil level frequently and fill as needed.
NOTE:
Bar and chain oil is required to properly lubricate the guide
bar and saw chain. The chainsaw is equipped with an
automatic oiler that deposits oil on the bar and chain when
running, keeping them properly lubricated.
1. Place the chainsaw on its side on a firm, flat surface.
2. Clean any debris from the cap area.
3. Remove the oil tank cap (Fig.5).
4. Carefully pour the bar and chain oil into the tank .
5 Replace the cap and make sure oil is visible in the tank.
INSTALLING/REMOVING THE
BATTERY PACK
To install:
Slide the battery pack to the battery docking port on the
product until it clicks (Fig.6). Double check the connection
between them.
WWW.SENIXTOOLS.COM