Publicidad
Idiomas disponibles
Idiomas disponibles
maintain complete control, release the cutting pressure near
the end of the cut without relaxing your grip on the chain
saw handles.
Don't let the chain contact the ground. After completing
the cut, wait for the saw chain to stop before you move the
chain saw. Always stop the motor before moving from tree
to tree.
CHARGING THE BATTERY PACK
WARNING:
This Lithium-Ion battery pack is shipped partially
charged. Fully charge the battery pack before
using it for the first time.
NOTE:
Charge batteries at a ambient temperature of 32°F-104°F
(0°C-40°C) and always store batteries at a ambient
temperature of 32°F-77°F (0°C-25°C).
1. Charge the Lithium-Ion battery pack only with the correct
charger.
2. Connect the charger to a power supply, the light indicator
of the charger turns red.
3. Align the raised ribs of the battery pack with the slot in
the charger (Fig.16).
4. Insert the battery pack into the charger, the light indicator
of the charger turns green and it flashes.
5. The charger will communicate with the battery pack to
evaluate the condition of the battery pack.
6. It is fully charged that the four lights of the battery turn
on. Disconnect the power supply from the charger.
Remove battery pack from the charger.
CHARGING INDICATOR
Press the light button on the battery pack to check whether
it needs to charge (Fig.17) .
Lights
Lighted
Off Blinking
WWW.SENIXTOOLS.COM
Status
The battery is at full
capacity.
The battery is at 75%
capacity.
WARNING:
Malfunctions may occur when the four lights
blinking in turns.
OVERHEAT PROTECTION
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the power tool/battery cool
before turning the tool on again.
OVERDISCHARGE PROTECTION
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the tool
and charge the battery.
MAINTENANCE
WARNING:
Failure to identify and replace damaged or worn
parts can cause serious personal injury. Inspect
the chainsaw regularly. Regular inspection
is the first step to proper maintenance.
Follow the guidelines below to maximize
safety and satisfaction. Have any damaged or
excessively worn parts replaced immediately.
WARNING:
Always remove the battery pack and let the
product completely cool down before performing
cleaning and maintenance work!
Always wear gloves to reduce the risk of injury
when operating this unit.
Only perform cleaning and maintenance work
according to these instructions! All further works
must be performed by a qualified specialist!
The battery is at 50%
capacity and requires
charging.
The battery is at 25%
capacity and requires
charging soon.
The battery is less than
5% capacity and requires
charging immediately.
19 - EN
Publicidad
