Publicidad
Idiomas disponibles
Idiomas disponibles
This chainsaw features an auto-oiling system
to keep the chain and guide bar properly
lubricated. The oil level
indicator shows the remaining oil in the
chainsaw. If the oil level decreases to below
bar and chain oil.
Operating the saw chain dry or with too little
shorten the product life span and cause rapid
wear to the saw chain and guide bar from
overheating!
bar discoloration! Adequate lubrication of
the saw chain during cutting operations is
essential to minimize friction with the guide
bar.
1. Position the product in a way that the chain
oil tank cap faces upwards.
2. Open the cap and check the oil level. If the
oil level is more than 1-2 cm blow the screw
mm space between the top of the oil and
the inside edge of the tank to allow for
expansion.
5. Put the oil cap back on. Make sure to
check the oil level after every 10 minutes
of use.
18
Clean the sprocket wheel. Using a disposable
lube gun, insert the needle nose into the
lubrication hole and inject grease until it
appears at the outside edge of the sprocket.
Make sure that the chain brake is
disengaged. Rotate the saw chain by hand.
Repeat the lubrication procedure until the
entire sprocket has been greased.
If the bar wears unevenly, the rails widen,
which may cause the chain to clatter and
the product is operated with a saw chain
which is too tight, this will contribute to rapid
bar wear.
To help minimize bar wear, maintenance of
the guide bar as well as the saw chain is
recommended.
1. Disassemble the guide bar and saw chain
in reversed order from assembly.
2. Check the oiling port for clogging and clean
if necessary to ensure proper lubrication
of the guide bar and saw chain during
operation. Use a soft wire small enough to
insert into the oil discharge hole.
3. Check the drive sprocket. If it is worn or
damaged due to strain, have it replaced by
an authorized service center.
4. Clear residue from the rails on the guide
bar using a screwdriver, putty knife, wire
brush or other similar tool. This will keep
the oil passages open to provide proper
lubrication to the guide bar and saw chain.
5.Check the guide bar 'rail' for wear: Hold a
WWW.SENIXTOOLS.COM
LUBE
Publicidad
