Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
will propel the tool in direction opposite to the wheel's
movement at the point of snagging.
d) Use special care when working corners, sharp
edges etc. Avoid bouncing and snagging the
accessory. Corners, sharp edges or bouncing have a
tendency to snag the rotating accessory and cause loss
of control or kickback.
e) Do not attach a saw chain woodcarving blade or
toothed saw blade. Such blades create frequent kick-
back and loss of control.toothed saw blade.
Safety Warnings Specific for Polishing Operations:
a) Do not allow any loose portion of the polishing
bonnet or its attachment strings to spin freely. Tuck
away or trim any loose attachment strings. Loose and
spinning attachment strings can entangle your fingers or
snag on the workpiece.
Additional Safety and Working Instructions
Never reach into the danger area of the machine when
it is running.
Immediately switch off the machine in case of conside-
rable vibrations or if other malfunctions occur. Check
the machine in order to find out the cause.
For accessories intended to be fitted with threaded
hole wheel, ensure that the thread in the wheel is long
enough to accept the spindle length.
Always use the auxiliary handle.
The workpiece must be fixed if it is not heavy enough
to be steady. Never move the workpiece towards the
rotating disk by hand.
Battery
Risk of fire! Risk of explosion!
Never use damaged, defective or deformed accumu-
lators. Never open or damage the accumulator or let it
fall on the ground.
Never charge the battery in an environment with acids
and easily flammable materials.
Protect the battery against heat and fire.
Battery to be used at the ambient temperatures bet-
ween 10°C and +40°C only.
Never put the battery on heaters and do not expose it
to strong sunlight for a long time.
After being subject to heavy load, let the battery cool
down first.
Short circuit - do not bridge the accumulator contacts
with metal parts.
The accumulator must be packaged (plastic bag, box)
or accumulator contacts must be sealed up for accu-
mulator disposal, transport or storage.
The Güde charger to be used only to charge the battery.
There can be malfunction or fire if different chargers are
used.
Vapours may leak out in case of unauthorised use or
when using a damaged accumulator. Bring fresh air and
seek medical advice if experiencing difficulties. Vapours
may irritate the respiratory system.
18
Working Instructions
Accumulators are supplied partially charged and must
therefore be fully charged before being used for the first
time.
• Charge the accumulator when the appliance is running
slowly or stops.
• A li-ion battery may be charged at any time without
any shortening of its life. Charging process interrupti-
on will not damage the accumulator.
• Charging process interruption will not damage the
accumulator.
• A significantly shorter operating time of a charged
battery means the battery life is over and the battery
must be replaced.
Dispose of the batteries in an environmentally
friendly manner.
Li-ion batteries are subject to the special disposal
obligation. Have any defective batteries disposed of by
a specialised shop. The battery must be taken out before
the appliance is scrapped. Damaged batteries may harm
the environment and your health if toxic vapours or
liquids leak out of such batteries.
Therefore, never send a defective battery by post, etc.
Please contact your local recycling centre.
Dispose of the batteries when discharged. We recom-
mend applying an adhesive tape on the poles to protect
them against short circuit. Never open the battery.
Maintenance
Remove the battery pack before
starting any adjustment, cleaning and
maintenance work on the device.
Repairs and works specified in these Instructions may
only be performed by qualified authorised staff. Use only
original accessories and original spare parts.
Keep the device, in particular the air vents, clean at all
times. Never spray water on the device body! Never
clean the machine and its components with solvents,
flammable or toxic liquids. Use only a damp cloth for
cleaning.
Caution! If the power cord of the appliance gets da-
maged, it must be replaced by the manufacturer or its
customer service or a similarly qualified person to avoid
danger.
Only a regularly maintained and treated appliance can
serve as a satisfactory aid. Insufficient maintenance and
care can lead to unforeseen accidents and injuries.
If necessary, a list of spare parts can be found at www.
guede.com.
Disposal
Any damaged or disposed electric or electronic
devices must be delivered to appropriate
collection centres.
Transport packaging disposal
The packaging protects the machine against damage
during transport. Packaging materials are usually chosen
based on environment aspects and waste treatment
principles and are therefore recyclable. Returning the
Publicidad
