Lenz rcB1200 Manual De Instrucciones página 94

O P E R A T I N G I N S T R U C T I O N S / E N G L I S H
reason, the battery does not need to be fully discha rged before charging.
 The battery pack can be in any operating mode when the charging process is
started. (POWER OFF, STANDBY, IN USE)
 The full charging capacity of the battery packs can only be conserved if the battery
packs are disconnected from the charger at the end of the charging process.
Charging times
Battery
Charging time
S A F E T Y F U N C T I O N S
 Short circuit protection: In the event of a short circuit at the contact or the heating element, the
product's integrated electronics system automatically turns off. The product is ready for use again
after removing the short circuit and brief connection with the charging plug.
 Protection against overcharging and exhaustive discharge: The product is protected
against overcharging and exhaustive discharge with the integrated electronics system.
I M P O R T A N T I N S T R U C T I O N S F O R U S E
 When using the cable of the Lenz insole (Lenz Heat Sole), plug it firmly into the battery pack until it
firmly locks into place.
 Never use the heated insole together with the heated sock as this may cause excessive heat!
 The optimal heating power is reached when the boots or soles are dry.
lithium pack insole rcB 1200:
 Do not use the highest heat setting for longer than a few minutes; continuous operation may result
in excessive heat!
 Always set battery packs to low or moderate heat levels to maintain comfortable foot warming
(heating should be almost undetectable).
1200 mAh
3 – 4 h
– 92 –