Ego Power+ FN1800E Manual Del Usuario página 10

NOTICE:
When the misting operation is finished, pull the
EN
intake tube out of the water and run the fan in misting
mode until all the water clears from the tube. This helps
prevent the residual water in the tube from causing
unexpected misting when the fan is started again.
USING THE FAN WITHOUT MISTING
If desired, this product may be used as a fan only, when
not connected to a water source. When not in use, always
place the intake tube in its storage area (See section
"STORAGE" in this manual) to protect it from damage and
contamination.
INTERNAL PROTECTION
When the misting function is activated but no water mist
is coming out:
◾
The water pump will keep running for a short while,
and then stop automatically to protect internal
electronics.
◾
Depending on misting mode, the misting indicator will
display one or two solid green lights for a short while,
and then flash green light(s) continuously as an alert
for the operator to:
a. Check if the intake tube is properly immersed into
water.
b. Check if the misting nozzle(s) is clogged, and
clean according to the "NOZZLE MAINTENANCE"
chapter.
c. Press the misting mode selection button to restart
misting.
MAINTENANCE
WARNING:
When servicing, use only identical
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician.
WARNING:
To avoid serious personal injury, always
remove the battery pack from the product when cleaning
or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
10
56 VOLT LITHIUM-ION CORDLESS MISTING FAN — FN1800E
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
NOZZLE MAINTENANCE (Fig. G)
WARNING:
Ensure that all misting nozzle
maintenance is performed properly to prevent water
leaks. The leaks can result in a slippery surface creating a
slip and fall hazard or cause property damage.
To clear the nozzles
1. Turn off the fan and remove the battery pack.
2. Remove the clogged brass misting nozzles by
rotating them in a COUNTERCLOCKWISE direction.
3. Disassemble each affected nozzle into parts.
4. To remove any foreign particles clogging or
restricting the nozzles, flush the nozzle parts with
water. To remove scale (mineral) buildup, clean the
nozzle parts with white vinegar or other de-scaling
agent as necessary.
5. Reassemble the nozzles.
NOTICE:
To prevent clogging, make sure that the nozzle
is assembled exactly as shown as Fig. G.
6. Reattach the clean nozzles.
FILTER MAINTENANCE (Fig. H)
Periodically examine the filter at the end of the intake
tube to make sure that it is in good condition.
1. Pull the filter off from the intake tube.
2. Unscrew the filter into parts and take out the sponge
mesh.
3. Rinse the sponge mesh or replace it if necessary.
4. Reassemble the filter and reconnect it to the intake
tube.
Fig. H parts description see below
H-1 Filter H-3
H-2 Upper Part H-4
FAN ENCLOSURE MAINTENANCE (Fig. I1 & Fig. I2)
WARNING:
Ensure the battery packs are removed
from the product before removing the guard.
Sponge Mesh
Lower Part