Ego Power+ LT1000E Manual Del Usuario página 4

READ ALL INSTRUCTIONS!
EN
READ OPERATOR'S MANUAL
WARNING:
To ensure safety and reliability, all
repairs and replacements should be performed by a
qualified service technician.
SAFETY SYMBOLS
The purpose of safety symbols is to attract your attention
to possible dangers. The safety symbols and the
explanations with them deserve your careful attention
and understanding. The symbol warnings do not, by
themselves, eliminate any danger. The instructions and
warnings they give are no substitutes for proper accident
prevention measures.
WARNING:
Be sure to read and understand all
safety instructions in this Operator's Manual, including all
safety alert symbols such as "DANGER," "WARNING," and
"CAUTION" before using this product. Failure to follow all
instructions listed below may result in electric shock, fire,
and/or serious personal injury.
Safety Alert
Read &
Understand
Operator's
Manual
Light Beam
Hot Surface
Class III
CE
UKCA
XX
4
56 VOLT LITHIUM-ION CORDLESS PORTABLE AREA LIGHT-LT1000E
Precautions that involve your
safety.
To reduce the risk of injury, user
must read and understand the
operator's manual before using
this product.
Do not stare into the light beam.
Risk of burns. Do not touch hot
surface.
Protection against electric shock.
This product is in accordance
with applicable EC directives.
This product is in accordance
with applicable UK legislation.
Waste electrical products
should not be disposed of with
WEEE
household waste. Take to an
authorized recycler.
Direct
Type or a characteristic of current
Current
V Volt Voltage
XX
min Minutes Time
A Amperes Current
mm Millimeters Length of size
lm Lumens Luminous flux
h Hours Time
GENERAL SAFETY WARNINGS
◾
Handle the light with care.
◾
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from
a distance).
◾
Do not cover off the lamp head while operating the
light (the lamp head heats up during operation and can
cause burns when the heat accumulates).
BATTERIES
◾
The battery supplied is partially charged (to ensure full
capacity of the battery, completely charge the battery
in the battery charger before using your power tool for
the first time).
◾
Do not use battery when damaged; it should be
replaced immediately.
◾
Do not disassemble the battery.
◾
Do not expose tool/battery to rain.
The light source of this light is not replaceable; when the
light source reaches its end of life the whole light shall
be replaced.
Original instructions