Publicidad
Idiomas disponibles
Idiomas disponibles
Cutting:
Set the cut element in the guide of the device - adjust the length and, if
•
necessary, the cutting angle (use the rulers on the device).
Plug the power cord into an electrical outlet.
•
•
Start the device with the blade away from the object to be cut and wait
until the blade reaches the target speed - if necessary, adjust its speed with
the knob located on the trigger.
Slowly lower the blade unit onto the workpiece, exerting a slight pressure
•
on the workpiece after the blade contacts the workpiece until the cut is
complete.
3.4.
Cleaning and maintenance
a)
After each use or after finishing work, remove the remnants of the material to
be cut, such as cuttings, shavings, etc.
b)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
Wait until the rotating parts stop.
•
c)
Use only non-corrosive cleaning agents for cleaning the surfaces.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
Publicidad
