Emerio DH-122844 Manual De Instrucciones página 10

Timer button
Timer ON setting:
When the appliance is off, press the button "TIMER", the corresponding indicator light will illuminate.
-
Keep pressing the button "TIMER" to select a desired ON time from 0-24 hours. The setting will be in
-
effect in approx. 10 seconds with no further operations.
The appliance will automatically turn on once the set time has passed.
-
Timer OFF setting:
When the appliance is working, press the button "TIMER", the corresponding indicator light will
-
illuminate.
Keep pressing the button "TIMER" to select a desired OFF time from 0-24 hours. The setting will be in
-
effect in approx. 10 seconds with no further operations. The digital display will turn back to show the
humidity.
The appliance will automatically turn off once the set time has passed.
-
Note: Press the button "TIMER" again to check the remaining time. Continue to press the button "TIMER" to
"00", the timer function will be cancelled.
Child lock function
Press and hold the child lock button for 5 seconds to turn on the child lock function. The indicator light of "LOCK"
will illuminate and all buttons (except for the child lock button) on the control panel will be invalid. Press and
hold the child lock button for 5 seconds again to turn off the child lock function.
Swing function
Press the swing button to turn on/off the swing function of the air outlet cover.
Defrosting function
The appliance will enter the defrosting function automatically. The indicator light of "DEF." will be on and the
compressor will stop working. Once the defrosting is finished, the indicator light of "DEF." will be off and the
compressor will resume working.
Notice:
1. The room humidity display range is 35~95%RH (room humidity < 35%, display "LO"; room humidity > 95%,
display "HI"). The working environment temperature of this appliance is 5~35 ℃ , and the working
environment humidity is 10~95%RH.
2. The compressor has a three-minute delay protection function. When the compressor is working and the
power is cut off accidentally, the compressor will not restart immediately after turned on again. It will start
to work in 3 minutes.
After switching mode or after the full water fault is removed, the compressor may enter the protection state
too. You must wait for 3 minutes before the compressor can start again.
3. The power indicator light also works relating to the compressor. The indicator light keeps illuminating when
the compressor is working. The indicator light keeps flashing when the compressor is not working.
4. The digital display on the control panel and the indication display on the front of the appliance are
synchronous. Both displays will dim in 10 seconds with no further operations. Press any button, the lightness
will recover.
DRAIN THE COLLECTED WATER
When the water tank is full, the water tank full indicator light will illuminate. The operation will stop
automatically and the buzzer will beep 15 times to alert the user that the water needs to be emptied from the
water tank.
- 9 -