Vacuuming with waste hose system (LP
Perform the suction process.
The vacuumed material only falls into the waste
hose when the device is switched off.
Regularly check the filling level since the device
does not switch off automatically.
With light waste or in case of clogging: Pull out the
sheathed cable to open the flap on the outlet (only
possible when the device is switched off).
Slightly pull down the waste hose, close it with 2 ca-
ble ties at a distance of 10 cm and cut it between
the cable ties.
Dispose of the waste sack in accordance with the
legal requirements.
Note: With light waste the length of the waste sack can
be up to 2 m without it bursting.
Indicator lamps
Lights up when the suction turbine is running
Blink codes for training the remote control (see ra-
dio remote control)
Remote control
The appliances
IVS 100/55
IVS 100/75
IVS 100/55 LP
IVS 100/75 LP
are equipped with a radio receiver for the remote control
option.
The training time and operation are described in the op-
erating instructions of the remote control.
Shutting down
Switch off the appliance using the On/Off switch.
If necessary, dismantle the accessory and rinse it
with water and let dry.
Empty the vacuuming material container (refer
chapter "Emptying vacuuming material container").
Vacuum and wipe the appliance inside and outside
with a damp cloth.
16
appliances)
Green
Emptying the vacuuming material container
Note
The vacuum material container must be emptied when
it is has filled up to approx. 3 cm below the upper edge.
Regularly check the filling level in the dirt receptacle,
since the device does not switch off automatically.
Switch off the appliance and secure it using the
parking brakes at the guide rollers.
Open the vacuum material container upwards at
the unlocking mechanism.
Pull out the vacuuming material container from the
appliance using the handle that has been provided
for the purpose.
Empty the vacuuming material container and insert
it back into the appliance using the reverse se-
quence.
Note
The vacuum material container can be lifted by cranes
at the handle. Maximum load for crane transport: 50 kg.
CAUTION
Risk of injury and damage! Note the total weight of the
vacuum material container when transporting with a
crane. Do not overload the container. Observe instruc-
tions on lifting with a crane.
Dust collection bag
You can insert a dust collector in the vacuuming mate-
rial container to empty the appliance without causing
dust.
Do not use the dust collection bag for wet vacuum
cleaning!
Insert the dust collection bag into the container and
attach it carefully to the container wall.
Put over the edge of the bag over the rim of the vac-
uuming material container.
Insert the vacuuming material container back into
the appliance.
After finishing use, close the dust collection bag
and remove it from the vacuuming material contain-
er.
Dispose off the dust collection bag with its contents
according to the applicable regulations.
– 5
EN