Publicidad
Idiomas disponibles
Idiomas disponibles
Fax +32 2 359 95 50
CONNECTION TO THE MAINS SUPPLY
Caution: We cannot be held responsible for any damage due to the wrong use or the non-
observance of this instruction manual.
The convection heater should only be connected to an earthed socket installed in
accordance with the regulations. Make sure that the supply voltage corresponds with the
voltage marked on the rating label.
This product complies with CE-directives.
MOUNTING
Before using the convection heater for the first time, the feet must be fitted to the base of the
unit and then secured with the screws provided (the assembly kit consists of two feet, two
screws and two washers). To do so, insert the feet on the hooks situated underneath the
appliance and fix them with a screw and a washer. When the appliance is correctly
assembled, it will be stable and ready for use. Never use the convection heater if the feet have
not been assembled.
OPERATION
After having installed your convection heater, insert the plug into an earthed power socket.
When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation. This smell will disappear very quickly.
The power selector allows you to choose the desired power. The higher the power, the faster
the heating will be.
The thermostat regulates the temperature in the room. A red pilot light will allow you to check
the thermostatic regulation. When the appliance is heating, this pilot light will be on. It will go
out when the desired temperature is reached.
Power selector
0
OFF
1
1000 W
2
2000 W
Note: the metallic parts of this appliance become hot during use, so if you need to move the
appliance during use, please use the side handles.
OVERHEATING PROTECTION
This heater is protected with an overheating protection that switches off the appliance
automatically in case of overheating, e.g. due to the total or partial obstruction of the grids. In
this case, unplug the appliance, wait about 10 minutes for it to cool and remove the object
that is obstructing the grids. Then switch it back on as described above. The appliance should
operate normally. Should the problem persist, please contact the nearest customer service.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
6
Assembly page 6/24
TEAM CH 1810 - 100603
Publicidad
