LG XB64 Manual Del Propietário página 8

Adjusting the general settings
1 Display setup menu
2 Select a desired option on the first level
3 Move to the second level
4 Select a desired option on the second level
5 Move to the third level
6 Change the setting
Adjusting the general settings -
more you can do
Adjusting the language settings
OSD (Menu Language) – Select a language for the Setup menu and on-
screen display.
Disc Audio/ Disc Subtitle/ Disc Menu – Select a language for the Disc Audio/
[Original]: Refers to the original language in which the disc was recorded.
[Other]: To select another language, press number buttons then ENTER to
enter the corresponding 4-digit number according to the language
code list in the reference chapter (Page 17). If you make a mistake
before pressing ENTER, press CLEAR.
[Off] (for Disc Subtitle): Turn off Subtitle.
8
ON REMOTE
SETUP
U U u u
i i
U U u u
i i
U U u u , ENTER
Disc Subtitle/ Disc Menu.
Adjusting the display settings
TV Aspect – Select which screen aspect to use based on the shape of your TV
screen.
[4:3] Select when a standard 4:3 TV is connected.
[16:9] Select when a 16:9 wide TV is connected.
Display Mode – If you selected 4:3, you'll need to define how you would like
wide screen programs and films to be displayed on your TV
screen.
[Letterbox] This displays a wide screen picture with black bands at
the top and bottom of the screen.
[Panscan] This fills the entire 4:3 screen, cropping the picture as
necessary.
TV Output Select – Select an option according to the TV connection type.
[RGB]: When your TV is connected with the SCART jack.
[YPbPr]: When your TV is connected with the
COMPONENT/ PROGRESSIVE SCAN jacks on the unit.
- If you change TV Output Select to RGB from YPbPr on the setup menu
especially when connecting the unit in the way of component video
connection, the screen turns black. In that case, connect the video cable to
MONITOR jack and select YPbPr on the setup menu again.
Progressive Scan (For Component Video connections) – Selects whether
the COMPONENT/PROGRESSIVE SCAN OUTPUT jacks output progressive
signal. If your TV accepts progressive format signals, you will enjoy accurate
color reproduction and high quality image by selecting [On]. If your TV does not
accept progressive format signals, select [Off].
If you set Progressive Scan to [On] in error, you must reset the unit. First,
remove the disc in the unit. Next, press and hold STOP for five seconds. The
video output will be restored to the standard setting, and a picture will be visible
on your TV.