LOKMAT Time 2 Manual Del Usuario página 6

Common Problem
Watch won't turn on
Please press and hold the power button for more than 3 seconds or the battery power may be too low, please
charge it in time.
Bluetooth is not connected or unable to connect
1) Please try to restart the watch and reconnect.
2) Please try to restart the phone's Bluetooth and connect again.
3) Do not connect the mobile phone to other Bluetooth devices at the same time.
Inaccurate measurement of heart rate/blood pressure/blood oxygen/ECG
1) Generally, it is caused by poor contact between the sensor of the watch and the human body during
measurement.
2) Please make sure that the sensor is in full contact with your wrist during measurement.
3) For people with darker skin and more hair on their arms, please turn on the enhanced measurement in
App[Device]> [Enhanced Measurement].
Sleep data is not accurate enough
1) Sleep monitoring is to simulate a person's natural falling asleep and waking time state, and it needs to be
worn normally.
2) Wear it when you fall asleep too late or when you fall asleep, errors may occur.
3) Sleep data is not monitored during the day, and the default sleep monitoring is from 9:30 pm to 12:00 noon
the next day.
For more frequently asked questions, please check App [My]> [FAQ].
Blood pressure
When entering the interface, the
green light at the bottom will
light up to start the
measurement. There will be a
vibration reminder when the
measurement is completed
within 30 to 60 seconds.
Women's health
After the watch is connected
with the APP, you can view the
female health reminder
information on the watch by
turning on the female health
reminder on the APP.
Drink water reminder
It can be turned on in the App
[Device]> [Drinking Water
Reminder]. After turning it on,
you can set the start, end time,
and reminder interval.
3
Blood oxygen
When entering the interface, the
green light at the bottom will
light up to start the
measurement. There will be a
vibration reminder when the
measurement is completed
within 30 to 60 seconds.
Sedentary reminder
It can be turned on in the APP
[Device]> [Sedentary Reminder].
After turning it on, you can set
the start, end time, and do not
disturb time.
Sleep
Display the sleep monitoring
status of the day, the data is
updated every day, and the data
can be saved synchronously
when connected to the APP.