Publicidad
Idiomas disponibles
Idiomas disponibles
links (1 t), and measure the diameter of the links
in the contact areas with the adjacent links, as
shown on the sketch.
b) Check that measures taken are within admit-
ted limits as shown on the following table:
The load chain must not be repaired.
When any of the above circunstances occur, or
when you wish to increase the lifting height of
the chain hoist, the whole chain must be substi-
tuted, following instructions on the next page.
The whole chain must be examined link by link.
The chain must be rejected when a link, or va-
rious links, show any of the following characte-
ristics:
a) cracks
b) dents or important grooves
c) Visible deformations
d) Severe corrosion
e) Deposit that can not be eliminated
f) Increase of the length of the chain measure,
or wear of links in articulation area, wich go be-
yond the limits indicated by the manufacturer.
Manual Chain Hoist Load (kg)
Di men si o ns o f t h e G- 8 0 ( T- 8) L oad Chai n (dim en sio ns a ccord ing to DIN -5 68 4)
Diameter and pitch (d x t) mm
Minimum diameter of links in
articulations areas, (d) mm
Chain rated lenght, measured over
11 links, (t) mm
Chain maximum length, measured
over 11 links, (t) mm
Dimensions of the Control Chain
Diameter and pitch (d x t) mm
16
Load Chain Grade - 80
500
1 000
5 x 15
7 x 21
4,5
6,3
165
231
169
236,50
4 x 19
5 x 21
2 000
5 000
3 000
8 x 24
10 x 28
9
7,2
308
264
315
269
5 x 21
6 x 27
6 000
a
10 000
13 x 36
11,7
396
405
6 x 27
Publicidad
