Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Before first use
Assembling the filtration system
The ventilator boasts 2 filtration systems on each side of the base. Follow the below instructions
to install them.
Make sure that the unit is switched off and unplugged.
Remove the air inlet cover and pre-filter.
Remove the protective plastic film from the HEPA filter and install the filter.
Reinstall the pre-filter, making sure to align the slots in the base with the ridges on the
pre-filter, then push the top until it clicks into place.
Reposition the air inlet cover and make sure that it is secured in place.
Inserting the remote control batteries
1.
Slide the remote control cover in the direction indicated by the arrow.
2.
Insert the 2x 1.5 V AAA batteries (not supplied), making sure to match the polarity,
as indicated in the battery compartment.
3.
Replace the cover.
4.
The remote control is now ready for use. Point the remote control at the infrared
sensor on the display (within 5 metres). Make sure there are no obstacles between
the fan and the remote control.
WARNING: Do not use rechargeable batteries with this product.
Before first use
•
Place the fan on a stable horizontal surface.
•
Make sure the air inlets/outlets are unobstructed. Do not cover the fan.
Operation
1.
Insert the connector into the AC adapter socket on the back of the unit. Then connect the
plug to the mains socket.
2.
Press the
button to switch on the unit. The current temperature will be displayed.
17
EN
Publicidad
