Steinberg Systems SBS-LZ-300D Manual De Instrucciones página 25

Caution: The use of excessive force is forbidden when removing the rotor!
3.3.
1. Open the unit cover as follows:
- grasp and slightly pull the cover opening handle (3) towards you. Lift the
cover while holding the handle.
2. Prepare the sample tubes to be centrifuged and place them in the instrument
so that they meet the following requirements:
- the tube should be filled to a maximum of 70% of its total volume,
- place the tubes symmetrically in the rotor. An example of tube placement is
shown in the figure below.
- The sample tubes facing each other must be of equal weight.
- Always verify the condition of the tubes being used. Do not place cracked or
deformed tubes in the unit!
3. Close the cover. When properly closed, the cover opening handle (3) will click
audibly.
4. Switch on the unit connected to the power supply using the I/O button on
the back of the unit.
Working with the unit