Publicidad
Idiomas disponibles
Idiomas disponibles
Thank you for purchasing this Pfister product. All Pfister products are carefully
engineered, and factory tested to provide long trouble-free use under normal
conditions. This product is easy to install using basic tools and our easy to
follow illustrated instructions.
1 BEFORE PROCEEDING
WARNING: This product comes complete for installation. Read all the
instructions completely before proceeding. Pfister recommends calling a professional
if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes. This product is heavy and fragile; use extreme care
with all parts!
2 SHUT OFF WATER SUPPLY
Locate main water supply inlets and shut off the water supply valves. These are usually
found near the water meter. If you are replacing an existing toilet, remove the old toilet
and wax ring from the floor and clean the floor surface thoroughly.
3
3 TOOLS RECOMMENDED
• FTFE Plumber's Tape
• Spatula
• Sealant
• Slotted screwdriver
• Pliers
• Adjustable wrench
• Cloth
Your installation may require other additional tools.
4
E
B
D
F
4 CONTENTS OF THE BOX
A Seat Cover
B Wax Ring
D Toilet Tank
E Toilet Lid
{Supply Valve, Flange, Hose, Rubber Gasket, [Tee Bolts (2), Nuts (2), Washers (2),
Plastic Washer (2), Decorative Cap (2)], [Brass Bolts (2), Wing Nuts (2) Washers (4)]}
G Installation Kit: {Cap (2), Screw (2), Washer (2), Nut (2),Spacer (2)}
• Safety Goggles
• Phillips Screwdriver
• Flashlight
G
A
C
C Toilet Bowl
F Installation Kit:
ENGLISH
5
5B
5 WORK AREA INSPECTION
Verify that the Waste Outlet Hole is 12" (305 mm) (5A) from the finished wall (5B).
6
A
C
6 WATER SUPPLY VALVE INSTALLATION
A. Slide Flange (6A) through Water Supply Pipe (6B) until it is tight to the wall.
B. Remove Sleeve (6C) and Cover Nut (6D) from Supply Valve (6E).
C. Insert Supply Valve (6E) into Water Supply Pipe (6B) until the end of Pipe sits flush
inside Supply Valve (6E).
7
7A
7 WASTE OUTLET HOLE PREPARATION
Place and align Tee Bolts (7A) into Flange Groves (7B) located on the Floor Flange
(7C) of Waste Outlet Hole as shown.
2
6A
6B
6C
6E
6B
7A
7B
5A
B
6E
6D
7C
Publicidad
