Publicidad
Idiomas disponibles
Idiomas disponibles
Recoil Starter
Grass Catcher
blaDe COnTrOl
The blade control is attached to the upper handle of the mower.
Depress and squeeze it against the upper handle to operate the unit.
Release it to stop engine and blade.
WarninG
This blade control is a safety device. Never attempt to bypass its
operation.
CUTTinG HeiGHT aDjUsTmenT leVer
One adjustment lever is located on the right rear wheel and one is
located on the right front wheel. Both levers have to be at the same
position to ensure a uniform cut. To adjust the cutting height, refer to
the Assembly Section.
Grass CaTCHer
The grass catcher, located at the rear of the mower, is used to bag
the grass clippings for disposal at another site. Once the bag is full,
remove it up through the handles using the strap provided and empty it
before any further mowing.
Craftsman Lawn Mowers conform to the safety standard of the American National Standards Institute (ANSI).
OPERATION
Blade Control
Cutting Height
Adjustment
Lever
Trail Shield
Gas Cap
Figure 10
meets ansi safety standards
13
Oil Fill
Primer
Trail sHielD
The trail shield is attached to the rear of the mower and is there to
protect the operator from flying debris. Do not use the mower unless
the shield is fully functional and in place.
reCOil sTarTer
The recoil starter is attached to the right upper handle. Stand behind
the unit and pull the recoil starter rope to start the unit.
primer
The primer is used to pump gas into the carburetor and aid in starting
the engine. Use it to start a cold engine, but do not use it to restart a
warm engine after a short shutdown.
Gas Cap
Remove the gas cap to add fuel to the fuel tank. Use clean, fresh,
regular unleaded gasoline.
Oil Fill Cap/ DipsTiCk
Refer to the Maintenance section for instructions on checking the oil.
spark plUG
Refer to the Maintenance section for instructions on spark plug
replacement.
Cutting Height
Adjustment
Lever
Spark Plug
Publicidad
