Cramer 82PST39 Manual De Instrucciones página 6

EN
1. Install the battery pack into the machine.
2. Press the safety lock button.
3. Pull the small safety lock button upward.
4. Press the trigger.
4.3 STOP THE MACHINE
Figure 7.
1. Release the trigger to stop the machine.
4.4 DELIMBING A TREE
Figure 8.
Make sure that there is nothing or nobody in the area where
the branches fall.
• Stand opposite the branch you will cut.
• Start to cut the higher branches.
• Then cut the lower branches.
• Cut downwards to prevent the bar from jamming.
4.5 LIMB TREE BRANCHES
Limbing is to remove the branches from a fallen tree.
Figure 9.
1. Keep the larger lower branches to hold the log off the
ground.
2. Remove the small limbs in one cut.
3. Limb the branches with tension from the bottom to up.
4. Keep the larger lower branches as a support until the log
is limbed.
5 MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5.1 ADJUST THE CHAIN TENSION
Figure 10.13.14
WARNING
CAUTION
CAUTION
WARNING
English
Wear protective gloves if you touch the chain, bar or areas
around the chain.
1. Loosen the chain cover by turning the chain cover lock
nut counterclockwise.
It is not necessary to remove the chain cover to adjust the
chain tension.
2. Turn the chain adjustment screw clockwise to increase
the chain tension.
3. Turn the chain adjustment screw counterclockwise to
decrease the chain tension.
4. When the chain is at the wanted tension, tighten the chain
cover.
5.2 SHARPEN THE CUTTERS
Sharpen the cutters if it is not easy for the chain to go into the
wood.
We recommend that your dealer, which has an electric
sharpener, perform important sharpening work.
Figure 15-18.
1. Tensioning chain.
2. Sharpen the cutters corner with a 4.5 mm diameter round
file .
3. Sharpen the top plate, side plate and depth gauge with a
flat file.
4. File all the cutters to the specified angles and the same
length.
During the process,
• Keep the file flat with the surface to be sharpened.
• Use the midpoint of the file bar.
• Use light but firm pressure when sharpening the
surface.
• Lift the file away on each return stroke.
• Sharpen the cutters on one side and then move to the
other side.
Replace the chain if:
• The length of the cutting edges is less than 5 mm.
• There is too much space between the drive links and the
rivets.
• The cut speed is slow
• Sharpening the chain many times but it does not increase
the cutting speed. The chain is worn.
6
CAUTION
NOTE
NOTE
NOTE